Zodiac t3 Guide Du Propriétaire page 9

Clearing the Diaphragm
To avoid serious injury, turn off the suction pump for the cleaner before performing this step.
If the cleaner stops, turn off the suction pump and
remove the cleaner from the water, then check the
diaphragm for blockage.
1. Turn cleaner over (see Figure 1).
2. Inspect diaphragm and push
through debris or obstacles to clear.
If the diaphragm is not blocked, check
it for wear or damage.
To remove the diaphragm:
1. Unthread the handnut and slide it off the engine
outer extension tube (see Figure 2), and set
aside. The upper thrust washer is designed to
stay inside the handnut and detach as a single
unit. (See Figure 3.)
2. Remove the engine (Figure 4) from the cleaner
body.
|
Owner's Manual Zodiac T3 Pool Cleaner
® ®
WARNING
ENGLISH
Diaphragm
Handnut
Upper Thrust Washer
Outer Extension Tube
Engine
Page 9
Figure 1
Figure 2
Figure 3
Figure 4