Samsung FlexWash WV60A9900A Serie Mode D'emploi page 74

Troubleshooting
Problem
Leaks water.
Has odors.
The tub or the water/drain hose
is frozen.
Water drains out immediately.
If an issue continues to occur, contact a local Samsung service center.
74 English
Untitled-5 74
• Make sure the door is properly closed.
• Make sure all hose connections are tight.
• Make sure the end of the drain hose is correctly inserted and
secured to the drain system.
• Avoid overloading.
• Use high efficiency (HE) detergent to prevent oversudsing.
• Excessive suds collect in recesses and can cause foul odors.
• Run cleansing cycles to sanitize periodically.
• Clean the door seal (diaphragm).
• Dry the washer interior after a cycle has finished.
• For frozen hoses, use warm water to disconnect the frozen hoses.
Soak them in warm water.
• For a frozen tub, fill the tub with warm water, and then wait for
about 10 minutes.
• For the hose connector, put a hot towel on the drain hose
connector.
• After thawing the hoses, reconnect them.
• Make sure the drain hose is not clogged, and is hung over the
drain hose hook. Fill the tub halfway with water, and try spinning
again.
• Lift the end of the drain hose to prevent water from draining.
Fill the tub halfway with water, and then run the spin cycle after
releasing the drain hose.
• Make sure the drain hose is installed correctly. See the
installation section of this manual and then adjust the position of
the drain hose as instructed.
• Make sure the washer drains completely if it is turned off by force.
If you operate the washer before it has drained completely, the
washer may supply water and drain simultaneously.
Action
2021-06-07 11:22:15