Samsung FlexWash WV60A9900A Serie Mode D'emploi page 25

STEP 5 Connect the water hose
Untitled-5 25
CAUTION
• Make sure you use a new water hose and that there
are rubber gaskets (B) inside the couplings (A) at
either end of each water hose. A water hose without
the gasket may leak.
• If there is a water leak, stop using the washer and
contact a local Samsung service center. A water leak
may cause electric shock.
• Do not stretch the water hose by force. If the hose
is too short, replace the hose with a longer, high-
B
pressure hose.
• To prevent leaks, make sure both water hoses are not
bent or kinked. A water leak may cause electric shock.
A
To connect the water hoses to the taps:
1. Connect one end of each water hose to the hot or
cold tap.
2. Turn the fittings by hand until they are tight, and
then tighten them an additional two-thirds of a turn
with a pliers. To prevent damage, do not overtighten
the fittings.
3. When done, pull the water hoses up and down to
check if they are properly connected.
English 25
2021-06-07 11:22:06