Samsung FlexWash WV60A9900A Serie Mode D'emploi page 24

Installation
STEP 3 Adjust the leveling legs
STEP 4 Put the rubber cups on the legs (Only for soft floor or surface)
24 English
Untitled-5 24
1. Gently slide the washer into position. Excessive force
may damage the leveling legs.
2. Level the washer by manually adjusting the leveling
legs.
3. When leveling is complete, tighten the nuts using the
Phillips screwdriver.
NOTE
An adjustable wrench or 17 mm open-end wrench is
required to loosen or tighten the leveling legs.
To protect a soft floor or surface, use the provided rubber
cups. You don't need to use the rubber cups on a hard
floor or on a pedestal.
1. Let two or more persons hold both sides of the
washer.
2. While slanting the washer to one side, put the rubber
cups under each leg of the washer one by one.
CAUTION
Make sure you have two or more persons insert the
rubber cups. Otherwise, the washer may fall, causing
physical or property damage.
2021-06-07 11:22:06