Lower Washer - Samsung FlexWash WV60A9900A Serie Mode D'emploi

Lower washer

Self Clean+
Certain usage and environmental conditions may result in some residue build-up or odor in the washer
drum. To prevent this build-up of residue or odor causing bacteria and keep your washer drum fresh and
clean, perform the Self Clean+ cycle at least once a month or every 40 cycles. Perform the recommended
procedure below when using the Self Clean+ cycle.
1. Remove all items from the washer drum and ensure the drum is empty. Laundry left in the drum during
the Self Clean+ cycle may be damaged.
2. Tap to turn the power on.
3. Tap LOWER.
4. Turn the Navigation dial to select Self Clean+.
5. Tap and hold lower
NOTE
• The water temperature for Self Clean+ is defaulted to Hot. This temperature cannot be changed.
• In the case where residue is present in the washer drum, add liquid chlorine bleach to the MAX level
line in the main-wash compartment before starting the Self Clean+ cycle. Do not add the liquid chlorine
bleach to the bleach compartment (This is only the case for Self Clean+ cycle). Do not exceed the max
line. Do not use or mix any other detergent or chemicals during the Self Clean+ cycle. If necessary, run a
Rinse+Spin Cycle after the Self Clean+ cycle has completed to help remove any remaining residue.
CAUTION
If there is chlorine bleach left in the washer drum for an extended period of time, rust can occur.
Self Clean+ reminder (
• After 40 washing cycles, the Self Clean+ LED reminder icon and the Self Clean+ cycle LED will blink on
the control panel for an hour and then turn off automatically.
• The reminder will appear on the control panel for 5 additional consecutive cycles before turning off. The
next reminder will not appear until another 40 cycles have been completed.
Untitled-5 65
.
)
English 65
2021-06-07 11:22:14