Safety Instructions - GUTMANN Rayo Notice De Montage

Masquer les pouces Voir aussi pour Rayo:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 19
Important Information
General
These Installation instructions contain
important Information which must be
observed in order that the extractor
hood can be installed and operated
without risk or difficulties. Keep these
Installation instructions in a safe place
for subsequent use. Follow the instruc-
tions of the cooking appliance manufac-
turer for Installation of extractor hoods.
The assistance of another person will
facilitate Installation. Replace defective
parts with original spare parts or with
parts named by the manufacturer.
Note: If extractor hoods feature external
fan motors, the Installation of the fan
motor can be found in separate installa-
tion instructions.

Safety instructions

Dinger
Installation, connection, startup and
repairs may be carried out by techni-
cians only. Technicians can specify a
suitable attachment and exhaust air
conduction for the extractor hood. The
attachment must be suitable for the
weight of the extractor hood and for the
load on the wall. Observe the pullout
values of the supplied wall plugs. These
have the following values depending on
the wall:
10 mm wall plugs:
Concrete B25
Brick MZ20
Solid calcium silicate brick KSV204.8 kN
If the wall is made of other uncertain
materials, consult a building specialist,
e.g. a structural engineer or an architect
to ensure t hat the extractor hood can
be installed securely.
Risk of injury
The hood structure may have sharp
edges caused by the manufacturing
process. Wear protective gloves during
installation.
Risk of electric shock
The mains voltage must correspond with
the specifications on the rating plate. The
rating plate is situated near the filters in-
side the hood. Connect the extractor hood
to a correctly installed earthed socket
only. The socket must be easily accessi-
ble following installation so that the ex-
tractor hood can be isolated if required. If
the extractor hood is to be permanently
connected (e.g. if there is no appropriate
socket), it may be connected to the mains
by an electrician only. If the extractor
hood is to be permanently connected, it
must be connected to a single electric
circuit with disconnector. Switches with a
contact opening of at least 3 mm and all-
pole switches, e.g. LS switches and con-
tactors, are regarded as disconnectors.
Before connecting the extractor hood to
the power supply, disconnect the mains
circuit(s). Before drilling fixing holes, en-
sure that there are no electric cables
which could be damaged by the drilling.
When preparing the power supply con-
nection, ensure that the extractor hood
can be connected without difficulty.
Observe local regulations.
Exhaust air conduction for exhaust air mode
The exhaust air must not be conducted
into a chimney which is used to remove
exhaust gases from appliances which use
fuel (e.g. gas). Observe the official regula-
tions for the removal of exhaust air. When
preparing the exhaust air route, ensure
that the extractor hood can be connected
9.4 kN
without difficulty. The exhaust air hose
5,2 kN
must not be kinked.
Solid fuel fireplaces
The extractor hood must not be installed
above a solid fuel fireplace which is a fire
hazard (e.g. flying sparks) unless the fire-
place has a sealed, non-removable cover.
Minimum distance from an electric
cooking appliance.
Minimum distance between the lower
edge of the extractor hood and hotplates/
hobs is min. 650 mm.
en
11

Publicité

Table des Matières
loading

Table des Matières