Connecting And Charging - Braun Oral-B SMART 1500 Mode D'emploi

• Replace brush head every 3 months or sooner if brush
head becomes worn.
• Clean brush head properly after each use (see «Cleaning»
paragraph). Proper cleaning ensures the safe use and
functional life of the toothbrush.
CAUTION
If you are undergoing treatment for any oral care condition,
consult your dental professional prior to use.
SAVE THESE INSTRUCTIONS
Description
a Brush head
b Pressure sensor light
c On/off button (mode selection)
d Handle
e Charge indicator light
f Low charge indicator light
g Charger
Accessories (depending on model):
h Brush head holder
i Brush head compartment with protective cover
j Travel case (design may vary)
Note: Content may vary based on the model purchased.
Specifications
For voltage specifications please refer to the bottom of the charging
unit.
Noise level: ≤ 65 dB (A)

Connecting and charging

Your toothbrush has a waterproof handle, is electrically safe and
designed for use in the bathroom.
• You may use your toothbrush right away or charge it briefly by
placing it on the plugged-in charger (g).
Note: In case the battery is empty (no charging light illuminated
(e/f) while charging or no reaction when pressing the on/off
button (c)), charge at least for 30 minutes.
• The green charge indicator light (e) flashes while the handle is
being charged. Once it is fully charged, the light turns off. A full
charge typically takes 12 hours and enables at least 2 weeks of
regular brushing (twice a day, 2 minutes) (picture 1).
Note: After deep discharge, the charge indicator light might not
flash immediately; it can take up to 30 minutes.
• If the battery is running low, the red charge indicator light (f) is
flashing for a few seconds when turning your toothbrush on/off and
the motor is reducing its speed. Once the battery is empty, the motor
will stop; it will need at least a 30-minute charge for one usage.
You can always store the handle on the plugged-in charging unit;
a battery overcharge is prevented by device.
Note: Store handle at room temperature for optimal battery maintenance.
Caution: Do not expose handle to temperatures higher than
122°F (50°C).
Recommended ambient temperature for charging is 41°F to 95°F
(5°C to 35°C).
Using your toothbrush
Brushing technique
Wet brush head and apply any kind of toothpaste. To avoid
splashing, guide the brush head to your teeth before switching on
the appliance (picture 2). When brushing your teeth with one of the
Oral-B oscillating-rotating brush heads guide the brush head
slowly from tooth to tooth, spending a few seconds on each tooth
surface (picture 5). When using the Oral-B «Deep Sweep» brush
head place the toothbrush bristles against the teeth at a slight
angle towards the gumline. Apply light pressure and start brushing
in back and forth motions, just like you would do with a manual
toothbrush.
4