Balluff BTL5-T1 M P-S103 Serie Notice D'utilisation page 14

BTL5-T1_ _-M_ _ _ _-P-S103
Micropulse Linear Transducer - Profile Housing
Table of Contents
1 Safety Advisory .................... 2
1.1 Proper application ................. 2
1.2 Qualified personnel ............... 2
1.3 Use and inspection ............... 2
1.4 Scope ..................................... 2
2 Function and
characteristics ...................... 3
2.1 Characteristics ...................... 3
2.2 Function ................................. 3
3 Installation ............................ 4
3.1 Transducer installation .......... 4
3.2 Floating magnets ................... 5
3.3 Captive magnets ................... 6
3.4 Using multiple magnets ........ 6
4 Wiring .................................... 7
5 Configuration ....................... 9
5.1 Default settings ..................... 9
5.2 Presets ................................... 9
6 Startup ................................ 10
6.1 Check connections .............. 10
6.2 Turning on the system ......... 10
6.3 Check output values ........... 10
6.4 Check functionality .............. 10
6.5 Fault conditions ................... 10
6.6 Noise elimination ................. 10
7 Versions (indicated on
part label) ............................ 10
7.1 Available stroke lengths
and magnets ........................ 10
7.2 Included in shipment ........... 10
7.3 Software ............................... 10
8 Accessories ........................ 11
8.1 Magnets ............................... 11
8.2 Control arm
BTL2-GS10-_ _ _ _-A .......... 11
8.3 Connection cables,
connectors ........................... 11
9 Technical Data .................... 12
9.1 Dimensions, weights,
ambient conditions .............. 12
9.2 Supply voltage (external) ..... 12
9.3 Control signals ..................... 12
9.4 Connection to the
processor ............................. 12
2
english
1 Safety Advisory
Read this manual before installing
and operating the Micropulse Trans-
ducer.
1.1 Proper application
The BTL5 Micropulse transducer is
intended to be installed in a ma-
chine or system. Together with a
PROFIBUS Master it comprises a
position measuring system and may
only be used for this purpose.
Unauthorized modifications and
non-permitted usage will result in
the loss of warranty and liability
claims.
1.2 Qualified personnel
This guide is intended for special-
ized personnel who will perform the
installation and setup of the system.
1.3 Use and inspection
The relevant safety regulations must
be followed when using the trans-
ducer system. In particular, steps
must be taken to ensure that should
the transducer system become de-
fective no hazards to persons or
property can result. This includes
the installation of additional safety
limit switches, emergency shutoff
switches and maintaining the per-
missible ambient conditions.
1.4 Scope
This guide applies to the model
BTL5-T1...P... Micropulse trans-
ducer.
An overview of the various models
can be found in Section 7 Versions
(indicated on part label) on
page 10.
Note: For special versions, which
are indicated by an -SA_ _ _ des-
ignation in the part number, other
technical data may apply (affect-
ing calibration, wiring, dimensions
etc.).