Scanning Service Bank Tips - Albrecht AE355M Mode D'emploi

Scanning Service Bank Tips

If You Want to do
This -
Begin scanning
Set up multiple
service banks to scan
Stop scanning
Resume scanning
Keep scanning after
the AE355M has
stopped on an active
channel
Here's How -
Press any service bank key; the bank label
flashes and the "SCAN" message moves
across the display screen. Scanning
automatically stops on an active channel and
displays that frequency (except for locked-out
channels which will be covered later in this
guide). It will stay on that channel until the
transmission ends.
Note: You must program channels into the
PRIVATE bank before you can later scan it.
Press a desired service bank's key until it
displays. Continue pressing other banks' keys
until all desired banks are displayed
(activated).
Press HOLD The scanner stays on the
.
displayed channel until scanning is resumed.
The bank's screen label remains steady and
does not flash.
Press one of the following keys to continue
scanning:
•
HOLD – Press this key to release the Scan
Hold and continue scanning. The bank's
screen label resumes flashing.
•
– Press this key to resume scanning.
•
Any bank key - If you press a different bank
key you will start scanning in that new bank
and the bank label will resume flashing.
•
L/O key - Press this key to lock out this
frequency and step to the next frequency.
If the AE355M stops on an active channel that
you do not want to monitor but you do not
want to lock out, press
the next frequency.
. You will scan to
21