General Product Care; Location; Cleaning; Birdies - Albrecht AE355M Mode D'emploi

PROBLEM
Search won't start
(cont.)
PROG key won't
work

General Product Care

Turn the scanner off before disconnecting the power.
Always press each keypad button firmly until you hear the entry tone for that key
entry.

Location

If strong interference or electrical noise is received relocate the scanner or its
antenna away from the source of the noise. A higher elevation, if possible, may
provide better reception. You might also try changing the height or angle of the
telescoping antenna.
Do not use the scanner in high-moisture environments such as the kitchen or
bathroom.
Avoid placing the unit in direct sunlight or near heating elements or vents.

Cleaning

Disconnect the power to the unit before cleaning.
Clean the outside of the scanner with a soft cloth. To prevent scratches do not use
abrasive cleaners or solvents. Be careful not to rub the LCD window. Do not use
excessive amounts of water.

Birdies

All radios may receive undesired signals or birdies. If your scanner stops during
Search Mode and no sound is heard it may be receiving a birdie. Birdies are
internally-generated signals inherent in the receiver's electronics. If the interference
is not severe you might be able to turn SQ clockwise to cut out the birdie. You can
also press SEARCH to resume searching.

Changing Band Plan

Only in cases where you use the scanner in other countries we recommend to
change the band plan from the factory preset "Band Plan 2" (for Germany) to "Band
Plan 1" (for UK and international use).
To change the Band Plan setting:
•
Switch the scanner off and disconnect scanner from power cable
•
Press HOLD and
36
SOLUTION
• Adjust the Squelch Control.
• Check the antenna connection.
Stop scan or search.
buttons, keep them pressed and re-connect the power