Parameter Setting (Setup) With Pc; Parameter Setting (Setup) From Front Panel - Icar RPC 8BGA Manuel Complet

ICAR PQS

18 PARAMETER SETTING (SETUP) WITH PC

You can use the PFC Remote Monitoring software to transfer (previously programmed) set-up parameters from the power factor
really to the hard drive of the PC and vice versa. The parameter may be partially transferred from the PC to the power factor
controller, transferring only the parameters of the specified menus.
The PC can be used to set parameters and also the following:
o Info page where you can enter application information, characteristics, data, etc.

19 PARAMETER SETTING (SETUP) FROM FRONT PANEL

To open the parameters programming menu (setup):
 turn the power factor controller in MAN mode and disconnect all the steps
 in normal measurements view, press  to call up the main menu
 select the icon . If it is disabled (displayed in grey) you must enter the password (see chapter 7. Password access).
 press  to open the setup menu.
The table shown in the illustration is displayed, with the settings sub-menus of all the parameters on the basis of their function.
Select the required menu with keys ▲▼and confirm with .
Press ◄ to return to the values view.
The following table lists the available submenus:
Cod MENU
M01 UTILITY
M02 GENERAL
M03 STEP
M04 MASTER OUTPUTS
M05 MASTER / SLAVE
M06 SLAVE 01 OUTPUTS
... ...
M13 SLAVE 08 OUTPUTS
M14 PROG. INPUTS
M15 PASSWORD
M16 COMMUNICATION
M17 BASE PROTECTIONS
M18 HARMONIC PROT.
M19 MISCELLANEOUS
M20 LIMIT THRESHOLDS
M21 COUNTERS
M22 ANALOG INPUTS
M23 ANALOG OUTPUTS
M24 ENERGY PULSES
M25 USER ALARMS
M26 ALARM PROPERTIES
Select the sub-menu and press
setting value.
To modify the setting of one parameter, select it and then press 
will not be possible to enter editing page and an access denied message will be shown. If instead the access rights are confirmed,
then the editing screen will be shown.
Settings: menu selection
DESCRIPTION
Language, brightness, display pages etc.
Panel/plant data
Capacitor step configuration
Programmable outputs of master device
Device role (master or slave)
Programmable outputs of slave device 01
Programmable outputs of slave device 08
Programmable digital inputs
Password access management
Communication channels parameters
Base protections of the panel
Harmonic protections (MCP5 module)
Various settings
Limit thresholds on measurements
Generic programmable counters
Programmable analog inputs
Programmable analog outputs
Pulses for energy meters increment
Programmable user alarms
Action caused by alarms
to show the parameters. Each parameter is shown with code, description and actual

Parameter
code
Parameter
description
Set-up: parameter selection
37 / 86
Present setting
value
Selected
parameter
.
If the Advanced level access code has not been entered, it
rev9 jan19