Technical Specifications - Multimetrix XG 2102 Notice De Fonctionnement

Technical specifications

Outputs
Signal waveforms
Frequency range
Frequency accuracy
Output level
Output impedance
Attenuator
Safety
Waveforms
Sine wave
Square wave
Triangle wave
TTL output
CMOS output
Duty cycle
Sweep function
Mode
Width
Rate
External VCF input
Input impedance
Frequency meter
Display
Frequency range
Accuracy
Time base
Input sensitivity
Max. input voltage
12
Specifications (valid at 25°C ± 5 °C after 1 hour warm-up time)
Sine, square, triangle, pulse, saw tooth, ramp
0.02 Hz to 2 MHz in 7 ranges (1, 10, 100, 1 k, 10 k, 100 k, 1 M)
5 % (1, 10 , 100 , 1 k, 10 k, 100 k,1 MHz (full scale)
±
10 V in open circuit,
±
50 Ω
5 %
±
20 dB fixed and continuously variable
Short circuits : TTL/CMOS and 50 Ohm inputs are protected against
input overload voltage
Distortion
Flatness
Rising and falling time < 120 ns
Linearity
Rise and Fall time
Output level
Rise and Fall time
Output level
10 % - 90 % (frequency is not fixed)
linear
variable, from 1:1 to 100 : 1
from 0,5 Hz to 50 Hz (20 ms at 2 s)
Input voltage : 0 to 10 V
approx. 10 kΩ
6 digits, green LED, Gate, MHz, kHz, Hz, mHz.
200 mHz to 50 MHz with Auto Range
5 % of range 1 count
±
10 MHz, 20 ppm
100 mVrms
250 Vpp
5 V into 50 Ω load
±
< 1 % from 0.2 Hz to 100 kHz
± 2.5 V to 2 MHz
> 99 % from 0.2 Hz to 100 kHz
< 25 ns
TTL level (H ≥ 2.4V, L ≤ 0,4V)
< 140 ns (max.)
4 V to 15 V 2 V, variable
±
Sweep : 2 % range Freq. by 0.1 V
English
2 MHz Function Generator