GE GPE12 Serie Manuel D'utilisation Et Instructions D'installation page 12

REVERSING THE DOOR SWING (CONT.)
BOTTOM HINGE
3
Remove the screws and bottom hinge with shim
from the right side. Remove the screw covers
from the left corner.
came with your refrigerator along with the screws
(and washers if applicable) removed earlier,
install the left hinge onto the bottom left of your
refrigerator. Make sure a shim is attached to
your left hinge before installation.
Place the screw covers into the holes now
vacant on the right.
TRANSFER FRESH FOOD
4
DOOR STOP TO THE LEFT
WARNING
instructions, leaving off parts, or overtightening
screws, can lead to the door falling off and result
in injury and property damage.
Remove the door stop and hinge pin sleeve from
the bottom of the right side of the door.
that came with your refrigerator, transfer the
hinge pin sleeve to the left side and install the
left door stop.
(Right Side)
12
Installation Instructions
(Left Side)
REHANG THE FRESH FOOD
5
DOOR
Make sure the
washer(s) are in place
on the bottom hinge
pin. Make sure the door
and vertically. Place the
fresh food door on the
bottom hinge, close the
door and tape it in place
with masking tape.
Remove the
Screw Covers
screw covers
from the left
edge of the door
and insert it into
the hole on the
opposite side.
INSTALL CENTER HINGE ON
6
THE LEFT
Remove the three screw covers on the left side
and install two of them on the right.
(and washers if applicable) removed earlier,
install the middle hinge on the left side.
Remove the tape holding the door shut.
NOTICE:
When assembled correctly, the
hinge is tight against the cabinet.
ATTENTION: The screws must be properly
tightened. Turn the screws until snug. Then
tighten the screws a minimum of 1/2 turn using
both hands.
49-60749-2