Technical Specifications; Service Life - KRATOS SAFETY RES-Q FA 70 101 20 Mode D'emploi

section). All belaying supports used must be checked before and after each use.
Using this product without having performed a visual and functional inspection can lead to accidents
resulting in severe injuries or death. The visual and functional inspection must be carried out by a
competent person. KRATOS SAFETY offers trainings for that purpose.
Perform the operating tests before each use.
Do not remove, add or replace any component of the device.
Chemical products: do not use the device in the event of contact with chemical products, solvents or fuels that could affect its
operation.

TECHNICAL SPECIFICATIONS:

Material: Res-Q: Steel / Karabiner: Aluminium / Kernmantle rope: Polyamide (EN 1891, class A).
Weight: 3.63 kg (FA 70 101 20) / 4.93 kg (FA 70 101 40)
Max. descent / lifting load: 150 kg (1 person)
Max. descent / lifting height: 300 m
Descent speed: approx. 0.8 m/sec
Descent controllable with eye bolts.
Can be used as a shuttle system.
KRATOS SAFETY certifies that this equipment has been tested and certified in accordance with EN 341:2011 class 1B
USE PROTOCOL:
After each usage, you must fill in the table pages 151-12. The rope of Res-Q MUST BE REPLACED as soon as the cumulative height
indicated in the table is reached. Maximum cumulative height must not exceed 1 500 m.
COMPATIBILITY FOR USE:
A fall arrest harness (EN361) is the only body-gripping device that may be used. All connectors used must be equipped with a lock-
ing system and be compliant with standard EN 362. It can be dangerous to create one's own fall protection system in which each
safety function can interfere with another safety function. Therefore, it is important to read the recommendations on using each
component in the system before use.
Be sure to strictly respect the rope characteristics and diameters indicated. In fact, some of them may be more or less slippery
and thus reduce the braking effectiveness. This can come from different factors: type and treatment of the sheath, inappropriate
diameter, wet or frozen rope (see specific notice for the rope). The characteristics of the belaying support can change during use,
especially due to wear, to soiling, or repeated descents along the same section of the belaying support (see specific notice for the
rope for inspections before use). If any defects are found or suspected, the rope should not be reused.
NEVER USE THE DESCENDERS WITH METAL WIRE ROPES.
A DESCENDER WITH ITS WORKING ROPE CANNOT BE CONSIDERED AS A FALL PROTECTION SYSTEM.
This product may only be used in combination with tested and certified products.
Only use this product with tested products or with products that have been recommended by KRATOS SAFETY. The following prod-
ucts correspond to the applicable PPE against falls from a height standards.
Tested and certified products:
Rescue overall/harness EN 1497 or EN1498
Energy absorber EN 355
Karabiner EN 362
Anchor device EN 795
Full body harness EN 361
Lanyards EN 354

SERVICE LIFE:

The service life of the product is 10 years (in accordance with the annual examination by a competent person authorized by KRATOS
SAFETY), it is linked to a variety of factors, such as frequent or incorrect usage, climatic conditions (humidity, frost and ice), strong
stresses, exposure to heat sources, ageing, exposure to chemicals, etc. It may be reduced according to use and/or the results of the
14