Control Features - HK Audio LINEAR 5 LTS A Manuel

LINEAR 5 LTS A 1.1
Leave enough space for proper ventilation!
1
0 dB
Gain
+6 dB
2
Input
3
Thru
LINEAR 5
LTS A
MADE IN GERMANY
7
Green = On
Red = Error
Power
8
On
Off
9
Mains
220-240 V~
50-60 Hz
3 A rated
current
Serial No.
4
4
Mid/High
Preset
5
+4 dBu
Sensitivity
L5 System
6
Flat
EQ
Contour
Caution: To reduce
the risk of electric
shock, grounding of
the center pin of
this plug must be
maintained.

1 Control Features

1 Gain
Turn the Gain knob to adjust and match the input's sensitivity the incoming
signal's level.
Adjusting the Gain knob to balance out the relative volume levels:
Use the Gain knob to adjust the proper balance of levels between the mid/
high unit and the subwoofer(s) for incoming line signals. The ratio of levels
between a subwoofer with the power output of an L SUB 4000 A and an
LINEAR 5 LTS A speaker should be at least 2:1. In other words, set the Gain
knob to 0 dB; that is, the center-notched 12 o'clock position.
2 Input
Use this electrically balanced combo XLR/ 1/4" (6.3 mm) port to patch in
the audio signal.
3 Thru
This passive parallel output routes the signal patched into the input back
out again.
4 Mid/High Preset
Use this rotary selector to set the right fi lter preset for the LINEAR 5 LTS A
in the following confi gurations:
Single:
Choose this preset when operating speakers in standalone
mode; that is, one unit each per stereo side.
Cluster:
The Cluster preset optimizes the fi ltering when two speakers
are clustered (placed side by side) on each stereo side to
extend the horizontal coverage to around 140°.
Head Stack:
The Head Stack preset is the right choice when you want to
stack speakers on top of another. In this confi guration, the
Multicell Transformer enables ‚acoustically correct' coupling of
high-range frequencies and the longer speaker array does the
same for the midrange frequencies to signifi cantly boost the
SPL by about 6 dB and extend the system's range.
Head Stack Cluster:
This preset combines the benefi ts of a cluster and a head stack
to broaden the pattern of throw and extend the speakers'
reach.
5 Sensitivity
Use this switch to adjust input sensitivity to the signal source's level. You
have two options for maximizing gain, the standard ‚+4 dBu' setting and
‚L5 system.'
Set this switch to ‚L5 System' and the Gain knob to 0 dB (the center-
notched 12 o'clock position) if you want this unit to be perfectly matched
with other LINEAR series components.
6 EQ
The switchable EQ off ers two types of fi lters for shaping the input signal.
Set this switch to ‚Flat' if you wish to optimize the signal for a linear
frequency response. The ‚Contour' voicing takes the edge off of midrange
frequencies while maintaining a very transparent audio image.