Maintenance; Troubleshooting - SPORTSTECH CX608 Mode D'emploi

Cleaning:
The elliptical trainer can be cleaned with a soft cloth and mild detergent. Do not use abrasives or solvents on plastic
parts. Please wipe your perspiration off the elliptical trainer after each use. Be careful not get excessive moisture on
the computer display panel as this might cause an electrical hazard or electronics to fail.
Please keep the elliptical trainer, specially, the computer console, out of direct sunlight to prevent screen damage.
Please inspect all assembly bolts and pedals on the machine for proper tightness every week.
Storage:
Store the elliptical trainer in a clean and dry environment away from children.
PROBLEM
The elliptical trainer wobbles when in use.
There is no display on the computer console.
There is no heart rate reading or heart rate
reading or erratic / inconsistent.
The elliptical trainer makes a squeaking noise
when in use.

MAINTENANCE

TROUBLESHOOTING

Turn the rear stabilizer end cap on the rear stabi-
lizer as needed to level the elliptical trainer.
1. Remove the computer console and verify
the wires that come from the computer
console are properly connected to the wires
that come from the front post.
2. Check if the batteries are correctly posi-
tioned and battery springs are in proper
contact with batteries.
3. The batteries in the computer console may
be dead. Change to new batteries.
1. Make sure that the wire connections for the
hand pulse sensors are secure.
2. To ensure the pulse readout is more precise,
please always hold on to the handlebar grip
sensors with two hands instead of just with
one hand only when you try to test your
heart rate figures.
3. Gripping the hand pulse sensors too tight.
Try to maintain moderate pressure while
holding onto the hand pulse sensors.
The bolts may be loose on the elliptical trainer,
please inspect the bolts and tighten the loose
bolts.
41
SOLUTION