Scale Lighting; Setting Scale Lighting; Separate Switch Or Dimmer For Scale Lighting; Setup Mode - Vetus WSD834 Manuel D'utilisation Et Instructions D'installation

3 .4 Scale lighting

3 .4 .1 Setting scale lighting

Press the LIGHT but-
ton when in normal
display.
The value set for the
scale lighting will be
displayed flashing.
The scale lighting (
L0
by pressing the LIGHT button one or more
times.
If the button is not pressed within 5 sec. the
original setting will be maintained.
3 .4 .2 Separate switch or dimmer for the
scale lighting
If a separate switch or dimmer is used for
setting the scale lighting the set value for the
scale lighting must always be set to
External).
(See Chapter 10 for the connection diagram
for a separate switch or dimmer.)

3 .5 Setup mode

3 .5 .1 Summary

Press the SET button (see Section 2.2) one or
more times when in normal display. The follow-
ing functions will be displayed in turn:
St01 Change wind speed unit
St02 Set wind speed alarm
St03 Set wind speed damping
St04 Set wind direction damping
St05 Calibrate wind direction (see Chapter 4)
St06 Calibrate ship's speed (see Chapter 4)
St07 Select indicator type
22
10.0312
WSD834M115
- ) can be changed
L5
(Light
LE

3 .5 .2 Change wind speed unit

The standard wind speed unit is [m/s]. This
can be changed to [kts] or [Bft].
Press the SET button
once.
will be dis-
St01
played briefly.
Use the or but-
ton to set the correct
wind speed unit.
Confirm the setting
by holding the SET
button pressed in for
2 sec.

3 .5 .3 Wind speed alarm

It is possible to set a wind speed alarm.
The wind speed alarm is normally switched
off.
Press the SET button
twice.
will be dis-
St02
played briefly.
Wind speed/ wind direction indicator WSD834
WSD834M131
WSD834M163
WSD834M164
WSD834M132