Attaching A Vacuum Cleaner - Bosch 3725DEVS Consignes D'utilisation/De Sécurité

2610051952.qxp_3725DEVS 8/16/18 2:01 PM Page 10
CLEANING AND EMPTYING
THE DUST CANISTER
It is recommended to loosen dust from the
microfilter by gently striking it against a solid
surface (Fig. 7).
To empty, lift lid of canister. Knock excess dust
out of the micro filter, or remove dust with your
fingers or a soft brush (Fig. 8).
FIG. 7

ATTACHING A VACUUM CLEANER

Dust collection can also be achieved by
attaching the tool to a vacuum cleaner / dust
extractor, hose and adapter, if necessary (all
sold separately).
1. Attach the hose to the vacuum cleaner /
dust extractor.
2. Attach the RS006 adapter to the dust port.
3. Attach the hose to the RS006 adapter in
one of the following ways (Fig. 9):
FIG. 9
DUST PORT
VX120
RS006
VAC002
-10-
You may notice that all the dust may not come
out of the canister. This will not affect sanding
performance but will reduce dust collection
efficiency.
NOTE: Do not wash the micro filter with soap
and water. Dust may become more firmly
lodged in the pores, which will reduce dust
collection, and damage the micro filter.
FIG. 8
- Bosch VH-series hoses - The VX120 hose
adapter is required (included with VH-series
hoses).
- Other 35mm and 22mm hoses, such as the
Bosch VAC-series hoses - Connect hose
directly to the RS006 adapter.
- Common 1-1/4" or 1-1/2" hoses - The
Bosch VAC002 or VAC024 adapter is
required.
BOSCH VH-SERIES HOSE
BOSCH VAC-SERIES HOSE
VAC024
1-1/4"
OR
1-1/2" HOSE