Klarstein AURELIA COLETTE Mode D'emploi page 22

EN
22
5
Before the first operation
• Before use, check the voltage on the device badge. Connect the equipment to an
outlet that corresponds to the voltage of the equipment.
• Check the correct functioning of the device by changing the speed and switching
the light on and off.
• Remove the suspension hook and slide the lower part of the chimney downwards
until it rests against the body of the cooker hood.
• Use a stainless steel cleaner and polish the stainless steel parts of the appliance.
Installation (Vent outside)
Note: When the range hood and appliance supplied with energy other than
electricity are simultaneously in operation, the negative pressure in the room must be
not exceed 4 Pa (4 x 10
Installation (Vent inside)
If you do not have an outlet to the outside, exhaust pipe is not required and the
installation is similar to the one show in section "Installation (Vent outside)".
When using the hood in extraction
mode, attach the exhaust pipe to
the ceiling before lowering the
lower chimney section.
-5
Bar).