Klarstein AURELIA COLETTE Mode D'emploi page 21

2
3
4
If your cooker hood is to be
operated in extraction mode, you
should connect the exhaust duct
to the ceiling adapter at this point.
Fasten the upper chimney section
to the hanging plate using the 4
self-tapping screws. Slide the lower
chimney section onto the angle
bars and lift it up until it sits directly
under the upper chimney section.
If the glass hood is not factory pre-
assembled, it should be attached
to the top of the main hood body
at this time.
Slide the main body of the cooker
hood onto the angle bars and
secure it with 16 screws (M5).
Tighten the screws properly.
Important: This step of the
installation process MUST be
performed by two people.
EN
21