Detergent Cleaning Precautions; Miscellaneous Safety Precautions - Mi-T-M THE WORK PRO WP Serie Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

6
IMPORTANT SAFETY WARNINGS

DETERGENT CLEANING PRECAUTIONS:

1. DO NOT use solvents or highly corrosive detergents or acid type cleaners
with this pressure washer. Use only Mi-T-M detergents.
2. KNOW YOUR DETERGENTS! Be prepared to tell a physician exactly what
you are using in the event of an emergency. Read the Material Safety
Data Sheet (MSDS) provided with your detergent and all detergent labels.
Follow all appropriate instructions regarding preparation use, safety and
transportation. Keep ALL detergents out of the reach of children.
3. DO NOT use this pressure washer to dispense hazardous detergents.
4. DO NOT alter the detergent injection feature in any manner not prescribed
in this manual. Use only genuine Mi-T-M replacement parts for necessary
repairs.

MISCELLANEOUS SAFETY PRECAUTIONS:

1. NEVER ALLOW CHILDREN OR ADOLESCENTS TO OPERATE THIS UNIT!
2. Read and follow all handling, operations, maintenance and safety instructions
listed in this manual and the Engine Operator's manual that accompanies
this unit, and provide such information to ANYONE who will be operating
this unit.
3. In freezing temperatures, the unit must always be warm enough to ensure
there is no ice formation in the pump. DO NOT start this unit if it has been
transported in an open or underheated vehicle without first allowing the
pump to thaw.
4. When connecting the water inlet to the water supply mains, local regulations
of your water company must be observed. In some areas the unit must
not be connected directly to the public drinking water supply. This is to
ensure that there is no feedback of the detergents into the water supply.
(Direct connection is permitted if a back flow preventer is installed.)
5. DO NOT allow any part of your body or the high pressure hose to make
contact with the muffler. Avoid dragging the hose over an abrasive surface
such as cement. This causes wear and eventual rupturing.
6. High pressure hoses should be inspected daily for signs of wear. If evidence
of failure exists, promptly replace all suspect hoses to prevent the possibility
of injury from the high pressure spray. If a hose or fitting is leaking , NEVER
place your hand directly on the leak.
7. DO NOT operate the unit without all protective covers in place.
8. NEVER run the unit with the governor disconnected or operate at excessive
speeds.
9. To reduce the risk of injury, maintain a safe distance for persons while
operating this unit. Close supervision is necessary when operating the unit
near children.
10. DO NOT leave pressurized unit unattended. Shut off the unit and release
trapped pressure before leaving.
11. DO NOT move the unit by pulling on the hose.
WP-Cold Water Direct Driven Operator's Manual

Publicité

Table des Matières
loading

Table des Matières