IPC Green Tube Manuel D'instructions page 11

TRANSLATION OF ORIGINAL INSTRUCTIONS
This text has been carefully checked. Should any printing
errors be noted, these should be communicated to the
manufacturer.
With the aim of improving the product, we reserve the right
to update this publication without notice.
This booklet may not be reproduced in any form without
the manufacturer's authorisation.
Hazard levels
Warning
!
Identifies a risk situation which could lead to serious injury.
FOREWORD
!
Warning
This publication must be read before setting up, starting and
using the equipment. It is an integral part of the product itself.
Read the warnings and instructions contained in this booklet
carefully. They provide important information on the safe use
and maintenance of the equipment. Pay particular attention to
general safety instructions.
Keep this booklet in a safe place for future consultation.
These equipment are constructed according to current safety
standards and regulations.
The contents of this booklet should be brought to the attention
of the user.
CLASSIFICATION
The user of this appliance must respect the specified operating
conditions with particular regard to the following classification:
This appliance equipped with electric motor is classified as a
class I appliance in terms of protection against electric shock.
The equipment is adjusted in the factory and all safety devices
are sealed. Their adjustment must on no account be altered.
The equipment must always be used on solid flat ground.
Failure to comply with this could constitute a source of danger.
The equipment must not be used in corrosive or potentially
explosive atmospheres (vapours or gas).
English
GENERAL SAFETY RULES FOR
! Warning
- Electrical connections must be carried out
in respect of current legislation
ce with the provisions of the IEC 60364-1
standard) and in accordance with the manu-
facturer's instructions.
Check that the installation and sockets are
adequate for the maximum power of the
appliance indicated on the rating plate (W).
- If in doubt, consult a qualified electrician.
The correct plug should be fitted by a quali-
fied electrician.
- The manufacturer declines all liability
for damage to persons, animals or things
caused by faulty or incorrect connection.
- Before connecting the equipment, check
that the specification given on the rating plate
corresponds to that of the mains electricity
supply.
- If the equipment is connected via an ex-
tension, use cables with an adequate cross
section, never less than 1,5 mmq.
- The electrical safety of the equipment is
guaranteed only when correctly and effi-
ciently earthed as specified in current elec-
trical safety legislation
the provisions of the IEC 60364-1
This fundamental safety requisite should
be verified. If in doubt, ask a professionally
qualified electrician to check the system
thoroughly.
It is recommended that the electric supply
to this machine should include a residual
current device that will interrupt the supply
if the leakage current to earth exceeds 30
mA for 30 ms or a device that will prove the
earth circuit.
- 11 -
THE USE
(in complian-
(in compliance with
standard).