Arrow T50ACD Mode D'emploi page 5

OPERATION
MAKE SURE YOU HAVE READ ALL SAFETY INSTRUCTIONS.
TO OPERATE THE TOOL
First position the contact safety tip on the work surface, without pulling
the trigger. Depress the contact safety tip until the nose touches the work
surface and then pull the trigger to drive a fastener.
OPERATION
LOADING STAPLES
1. Make sure tool is unplugged or powered off.
2. The T50ACD tool (or electric stapler) has a bottom load staple
™
magazine. Turn tool upside down and squeeze pusher assembly
(Fig 1).
3. Pull pusher assembly out until it stops to reveal the staple magazine
(Fig 2).
4. STAPLES: Place staples into magazine with the points facing up and
out of the tool (Fig 3a). Never attempt to completely remove pusher
assembly as this may damage the tool and void the warranty. Close
pusher assembly until it snaps into place.
8
Fig 1
FIRING TOOL
1. To fire your tool, place down on work surface depressing the contact safety on
the front of the tool. Once the contact safety is depressed, push the trigger to
fire staple. You must pick up the front of the tool and reactivate the contact
safety for each shot.
HOW TO DETERMINE PROPER STAPLE LEG SIZE
Fig 2
In choosing the proper staple leg length for a job, there are two basic things
to consider:
1. Thickness of material to be stapled.
2. Hardness of the wood.
As a general rule, in hardwood, approximately 3/16" to 1/4"penetration
Fig 3a
into the wood is sufficient...and for softwood – up to approximately 3/8"should
On very hard
be sufficient. The staple should be flush with the underlying surface, as shown
surfaces, firing in Figure 4b. However, if the staple used is not flush with the underlying surface,
recoil may interfere
as shown in Figure 4a – this means that too long a leg length has been used.
with nail/staple In that case, we recommend the next shorter leg length for desired results.
penetration.
A WORD ABOUT ARROW
Enhance driving
Only Arrow
power by firmly
performance of the T50ACD
placing one hand
Only genuine Arrow
on top of tool.
to ensure top fastening performance. Accept no substitutes. Always insist
on genuine Arrow
EXTENSION CORDS
1. If using an extension cord, wire thickness should be #14 gage or heavier.
2. Do not use extension cords that are damaged or in need of repair.
OPERATION
STAPLES
®
knows the proper staple tolerances required for best
®
Electric Stapler.
™
® T50 ® staples are made to these exact tolerances
® staples.
Fig 4a Fig 4b
9