Start Up; Installing The Sd Card - Snooper TRUCKMATE S7000 Mode D'emploi

To utilise the AURA™ Camera database you will need to register Truckmate and
perform a download. Please refer to 'System Requirements and Software Installation'
later in this Quick Start Guide for further information.

Start Up

1. Installing the SD Card

Before using Truckmate, you will need to install the SD Card included with the device.
The SD Card comes complete with a digital map of the UK and Ireland or Western Europe
depending on the model purchased and is also where the AURA camera database is
TM
stored if you choose to subscribe and download it.
Start by moving the 'Batt. ON/OFF' switch located on the back of the unit to the 'ON'
position, then remove the SD card from its packaging and insert it into the SD Card slot
as indicated. Switch on the device by pressing and holding the standby power button
located on the left hand side of the unit for 2 seconds. Press the 'Navi' icon from the menu
options. As soon as the 'Navi' icon is pressed, Truckmate will automatically synchronise
with the SD Card. Once the synchronisation is completed, the SD Card will not function
with any other device. Truckmate is now ready to navigate and the camera database can
be downloaded if necessary.
Please note that if the unit does
not activate when you press and
hold the standby power button for
2 seconds it may require charging.
Refer to the section 'Charging the
internal battery' later in this guide.
SD Card
4 • UK