JB Systems COB-PLANO Mode D'emploi page 8

ENGLISH
 Use DOWN and UP buttons to change the sensitivity of the build-in microphone (00 = minimal sensitivity,
99 = maximal sensitivity).
 Press the ENTER button to confirm.
AUTOMATIC CHASE MODE:
Used to set the automatic Chase Mode so colors will change automatically at a constant speed.
 Press the MENU button until P.. (P followed by 2 numbers) is shown on the display.
 Use the DOWN and UP buttons to select one of the 5 automatic programs (P08-P09-P10-P11-P00).
 (01 to 07 are fixed colors)
 Press the ENTER button to confirm  now you can set the speed for the automatic chase (SP-0 to SP-9
on the display). If you have selected a fixed color in the previous step (P01 – P07) then you don't need to
set a speed because this will have no influence at all.
 Press the ENTER button to confirm  now you can set the speed for the stroboscope function. (F on the
display)
 Use DOWN and UP buttons to change the flash rate (F- - 0 = slow, F- - 9 = fast).
OPERATING INSTRUCTIONS
A. Standalone 1unit:
 Just connect the projector to the mains.
 Select one of the automatic, sound or static color modes
 Refer to chapter HOW TO SETUP to learn how to make the settings.
B. Two or more units in master/slave setup:
 Connect the units together. Refer to the chapter "electrical installation" to learn how to do this.
 Select one of the automatic, sound or static color modes on the master (the first projector in the DMX
chain)
 Set all the other projectors in SLAVE mode
 The projectors will now follow the program of the master projector so they all work synchronously.
C. Controlled by the wireless remote controller:
To be able to use the wireless remote control, you need to enable this option in the projector:
 Press the MENU button until rC.. (rC followed by on or oF) is shown on the display.
 Use the DOWN and UP buttons to enable or to disable the remote control option (rCon = remote
control enabled, rCoF = remote control disabled).
 Press the ENTER button to confirm
Functions:
 BLACKOUT: is used to switch the LEDs off/on
 AR: activates the Automatic Random program. (AutoRun)
 S PR: is used to run the built-in programs. Use the + and – buttons to select the desired program
 FL: is used to activate the strobe (Flashing) mode. Use the + and – buttons to select the desired flash
frequency
 SP: is used to set the running speed when you are using the color change or the color fade modes.
Use the + and – buttons to modify the speed.
 D: is used to set the projector in DMX mode
 SA: is used to select the sound activated mode
 SL: is used to select the slave mode
 S, 0, 1, 2, 3, 4; 5, 6, 7, 8 and 9: these buttons are used to set the DMX address:
 Press the S button. The Red LED will turn on to show you the projector is ready to receive it's
DMX address.
 Press a number (from 0 to 9) to select the first digit of the DMX address. The projector turns
Green to show you the setting of the first digit was successful.
 Press a number (from 0 to 9) to select the second digit of the DMX address. The projector turns
Blue to show you the setting of the second digit was successful.
 Press a number (from 0 to 9) to select the third digit of the DMX address. The projector flashes a
couple of times in White to show you the setting of the last digit was successful.
 Press DMX MODE to save the new address into the memory
 R is used to set the intensity of the Red LED source. Use the + and – buttons to modify the intensity.
JB SYSTEMS
®
6/51
USER MANUAL
COB PLANO