JB Systems COB-4BAR Mode D'emploi page 11

ENGLISH
(50%, 75%, 100%, off). Don't forget that the brightness is also influenced by the master dimmer ! (=
BRIGHTNESS button)
 G is used to set the intensity of the Green LED source. Press this button several times to select one of
the 4 preprogrammed brightness levels. (50%, 75%, 100%, off). Don't forget that the brightness is also
influenced by the master dimmer ! (= BRIGHTNESS button)
 B is used to set the intensity of the Blue LED source Press this button several times to select one of
the 4 preprogrammed brightness levels. (50%, 75%, 100%, off). Don't forget that the brightness is also
influenced by the master dimmer ! (= BRIGHTNESS button)
 W is used to set the intensity of the White color (Red + Green + Blue together) Press this button
several times to select one of the 4 preprogrammed brightness levels. (50%, 75%, 100%, off). Don't
forget that the brightness is also influenced by the master dimmer ! (= BRIGHTNESS button)
 Pr1, Pr2, Pr3, Pr4: These buttons are used to run the built-in color chase programs. Brightness, speed
and flash rate can be adjusted with the buttons BRIGHTNESS, SP and FL
 D1, D2, D3, D4: These buttons are used to run the built-in color fade programs. Brightness, speed and
flash rate can be adjusted with the buttons BRIGHTNESS, SP and FL
 SA1, SA2, SA3, SA4: These buttons are used to run the built-in sound controlled chase programs.
Brightness and flash rate can be adjusted with the buttons BRIGHTNESS and FL
Note: Maximum distance between the wireless remote and the fixture = +/- 10m
D. Controlled by the LEDCON-02 Mk2:
Follow the steps below to control the bar using the LEDCON-02 Mk2
 Press the MODE button until DMX MODE is shown on the display.
 Select the 18CH DMX mode and set the DMX address to 001.
 Press the MODE button until LED EFFECT OUT is shown on
the display and choose: DMX CONTROL OFF (important!)
 Set the LEDCON-02 Mk2 to 4CH mode (switch on the back of
the controller)
 For instructions on how to use the LEDCON-02 Mk2: please
check the user manual of this controller.
Important notes:
 The COB-4BAR is only compatible with LEDCON-02 Mk2,
not with the LEDCON-02 !
 While used with the LEDCON-02 Mk2, the 2 power outputs (12+13) cannot be controlled, they will
be on all the time!
 Infra red control must be switched off (IR ACTIVE = OFF)
E. Controlled by the optional foot controller:
To be able to use the foot controller, you need to enable this option in the 4BAR:
 Press the MODE button until SLAVE & FOOT CONTROL is shown on the display.
 Press the ENTER button to confirm.
General description of the foot controller:
 ROTARY Knob: is used to set the
sensitivity of the build-in microphone
for the sound controlled mode.
 MODE Switch: is used to select one
of the 3 different working modes:
COLOR, SOUND, PROGRAM
 UP & DOWN Switches: are used to
select the different program options
 BLACKOUT Switch: is used to
switch the LEDs off/on or to select
the Full On function.
Modes & Functions :
Press the MODE pedal to select the different working modes.
 COLOR Mode (Red LED is lit): in this mode you can select different static colors
 UP & DOWN pedals: can be used to select one of the different static colors.
JB SYSTEMS
®
9/74
USER MANUAL
COB-4BAR