JB Systems COB-4BAR Mode D'emploi page 9

ENGLISH
IMPORTANT: Don't forget the bar is equipped with a master dimmer. If the output seems to be too
low or if there is no light output at all, please check the MASTER DIM setting !
AUTOMATIC CHASE MODE:
Used to set the automatic Chase Mode so colors will change automatically at a constant speed.
 Press the MODE button until 01.STATIC or xx.EFFECT (number 02 to 14 followed by EFFECT) is shown
on the display.
 Press the ENTER button to enter the configuration mode
 The actual mode (static or effect mode) is blinking on the display
 Use the DOWN and UP buttons to select one of the 11 chase modes (03, 05, 06, 07, 08, 09, 10, 11, 12, 13
or 14.EFFECT).
 Press the ENTER button to confirm
 Speed starts blinking on the display: Use the DOWN and UP buttons to set the desired running speed (00
= slow, 99 = maximum speed)
 Press the ENTER button to confirm
 Flash starts blinking on the display: Use the DOWN and UP buttons to set the desired speed for the
stroboscopic effect (00 = off, 99 = maximum speed)
 Press the ENTER button to confirm.
Remark: if you have selected 13.EFFECT or 14.EFFECT, you can choose 2 colors for your chase program:
 C1 will blink on the display
 Use the DOWN and UP buttons to and UP buttons to select the first color of your chase program.
 Press the ENTER button to confirm
 C2 will now blink on the display
 Use the DOWN and UP buttons to and UP buttons to select the second color of your chase program.
 Press the ENTER button to confirm
IMPORTANT: Don't forget the bar is equipped with a master dimmer. If the output seems to be too
low or if there is no light output at all, please check the MASTER DIM setting !
AUTO RUN:
Used to start the automatic Random Chase Mode. The bar will play each individual chase program at
random. The speed and strobe speed that you have set for each individual chase program will be
used during this show. (see previous description: AUTOMATIC CHASE MODE)
 Press the MODE button until AUTO RUN is shown on the display.
 Press the ENTER button to enter the configuration mode
 FQN will start blinking on the display.
 Use the DOWN and UP buttons to change the number of times each program should be repeated before
to go automatically to the next automatic program. (01 to 99 times)
 Press the ENTER button to confirm
FLOW INVERT
Used to invert the flow direction of the automatic chases. This can be useful when you use several
bars together in master / slave mode
 Press the MODE button until FLOW INVERT is shown on the display.
 Press the ENTER button to enter the configuration mode
 Use the DOWN and UP buttons to select ON (flow is inverted) or OFF (flow is not inverted)
 Press the ENTER button to confirm
MASTER DIM
This is the general master dimmer for ALL the build-in effect of the 4BAR.
 Press the MODE button until MASTER DIM is shown on the display.
 Press the ENTER button to enter the configuration mode
 Use the DOWN and UP buttons to change the general dimmer level of the 4BAR
 Press the ENTER button to confirm
If you would have the impression the 4BAR is not working, please check if this MASTER DIMMER is
not set to zero or to a too low level !
JB SYSTEMS
®
7/74
USER MANUAL
COB-4BAR