Camera Source; A/V-In, Hdmi Source - XZENT X-127 Manuel De L'utilisateur

CAMERA SOURCE

X-127 features 2 individual camera inputs. CAM1 and CAM2 AV IN are found on the 24-PIN AV
cable (connector B).
The device will activate the camera power via 12 VDC (PWR Cam1 12VDC or PWR Cam2
12VDC at the 24-PIN AV wire) to allow picture input of one camera picture at a time. Do not
connect the camera power to a permanent power to avoid overlaying of CAM1 and CAM2 pic-
ture and continious duty.
If the XZENT Setting is set to CAMERA>CAM1+CAM2, the camera source is in dual mode and
you can press the CAM Switch button to change the picture from CAM 1 to CAM2. By default
the XZENT is set to CAMERA>CAM1.
Each camera source has a different color of camera lines, the can be turned off and on in
XZENT main settings.
To adjust the camera lines to your requirements, activate the corresponding CAM source by
pressing the CAM Icon in main menu or enter reverse gear (CAM 1). When the camera picture
is visible, press the gearwheel to enter the camera settings. Each camera source can save an
individual camera line adjustment.
22
The A/V-IN and HDMI source can be entered among other ways via the home screen icon.
The source will provide you the A/V-IN or HDMI signal input to your XZENT device. There is no
specifi c touch operation here besides the back to home screen button.
Operation Buttons
1. Return Press to return to the home screen.
1

A/V-IN, HDMI SOURCE

23