Starting The Test Kit - Parker Test-kit Manuel D'utilisation

4.

Starting the Test Kit

ATTENTION!
Risk of material damage though residues of demineralised water in the supply
tank.
During the quality control of the test kit, a function test is completed using
demineralised water. Therefore, residual demineralised water could still be in the
supply tank.
► Check the compatibility of demineralised water and application for use!
► If they are incompatible, flush the supply tank with hydraulic fluid!
CAUTION!
Risk of injury through damaged test kit.
► Check the test kit for signs of damage prior to use!
► Never put a damaged test kit into operation!
► Send damaged test kits back to the manufacturer for repair!
CAUTION Risk of crushing!
Fingers or hands could be crushed when the hand grips are pushed together.
► Do not reach in between the two hand grips!
► Do not take hold of the piston rod!
► Do not reach in between the hand grips and supply tank!
ATTENTION!
Risk of material damage through soiling.
► Keep the test object, adapters and seals free of soiling!
ATTENTION!
Risk of material damage through exceeding the torque.
► Never exceed the maximum torque of 25 Nm for the ServiceJunior and
test object!
1 Before using the test kit for the first time, complete an initial start up of the test kit.
& "Utilizzando il kit di test frequentemente, ripetere la messa in funzione del kit
di test. & „Collegamento e sfiato del dispositivo sotto prova" a pagina ." on Page
11
V2.0/07/20
Starting the Test Kit
11