MSI Creator X299 Présentation Rapide page 67

▶ Dynamic Frequency Search Mode [Once]
Sets the search mode of the dynamic BCLK. This item will be available when the
Dynamic Frequency Search is enabled.
[Once]
[Each Power On] Run in every time when system is powered on.
▶ Dynamic Frequency Search Step (MHz) [Auto]
Sets the increase for running the dynamic BCLK. If set to Auto, BIOS will configure
this setting automatically. This item will be available when the Dynamic Frequency
Search is enabled.
▶ BCLK Amplitude [Auto]
Sets the value for BCLK Amplitude for overclocking. Higher value might benefit to
get higher overclocking.
▶ SRC Clock Amplitude [Auto]
Sets the value for SRC clock Amplitude.
▶ SATA Clock Amplitude [Auto]
Sets the value for SATA clock Amplitude.
▶ BCLK Slew Rate [Auto]
Sets the value for BCLK Slew Rate for overclocking. The value might vary
depending on the actual overclocking scenario.
▶ BCLK ORT Duration [Auto]
Sets the value for BCLK ORT duration for overclocking. The value might vary
depending on the actual overclocking scenario.
▶ Extreme Memory Profile (X.M.P.) [Disabled]
X.M.P. (Extreme Memory Profile) is the overclocking technology by memory module.
Please enable XMP or select a profile of memory module for overclocking the
memory. This item will be available when the memory modules that support X.M.P. is
installed.
▶ DRAM Reference Clock [Auto]*
Sets the DRAM reference clock. The valid value range depends on the installed CPU.
This item appears when a CPU that supports this adjustment is installed.
▶ DRAM Frequency [Auto]
Sets the DRAM frequency. Please note the overclocking behavior is not guaranteed.
Run once in the next system boot.
57
BIOS Setup