Normal Position (Online Mode) - Eaton Pulsar Serie Manuel D'installation Et D'utilisation

Normal position (online mode)

This operation must be carried out by qualified electrical personnel only.
Return to normal position from service position (bypass position).
1 2
3
I
5 6 7
1 - Push the red padlock in the center of
the manual bypass switch (1) to unlock it
NORMAL
1
2 - Set the bypass switch (1) to test
position.
Wait 3 seconds.
BYPASS
3 - Turn on the Normal AC source input
switch (2).
NORMAL
4 - Set the bypass switch (1) to normal
2
position.
BYPASS
NORMAL
4
BYPASS
5 - Press and hold the (I) (ON) button (3) for
3 seconds.
4
MX Frame performs an internal test
sequence.
LED (4) is ON, LEDs (5), (6), (7) are green.
The load is protected
O
3
7. Maintenance
34008486EN/AC - Page 41