Ec Declaration Of Conformity; Protecting The Environment - Black & Decker BEW220 Mode D'emploi

ENGLISH
Emptying the dust bag
The dust bag (2) should be emptied after every ten
minutes of use.
Pull the dust bag (2) to the rear and off the tool away from
u
the connection port.
Empty into a suitable receptacle and replace on tool.
u
Hints for optimum use
For user comfort, the tool can be operated with one or
u
two hands (fig. F, G, H). Do not place your hands over the
ventilation slots.
Do not exert too much pressure on the tool.
u
Regularly check the condition of the sanding sheet.
u
Replace when necessary.
Always sand with the grain of the wood.
u
When sanding new layers of paint before applying
u
another layer, use extra fine grit.
On very uneven surfaces, or when removing layers of
u
paint, start with a coarse grit. On other surfaces, start
with a medium grit. In both cases, gradually change to a
fine grit for a smooth finish.
Consult your retailer for more information on available
u
accessories.
Maintenance
Your BLACK+DECKER tool has been designed to operate
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.
Warning! Before performing any maintenance on the tool,
remove unplug the charger before cleaning it.
Regularly clean the ventilation slots in your tool using a
u
soft brush or dry cloth.
Regularly clean the motor housing using a damp cloth. Do
u
not use any abrasive or solvent-based cleaner.
Mains plug replacement (U.K. & Ireland only)
If a new mains plug needs to be fitted:
Safely dispose of the old plug.
u
Connect the brown lead to the live terminal in the new
u
plug.
Connect the blue lead to the neutral terminal.
u
Warning! No connection is to be made to the earth terminal.
Follow the fitting instructions supplied with good quality plugs.
Recommended fuse: 5 A.

Protecting the environment

Z
Separate collection. Products and batteries
marked with this symbol must not be disposed
of with normal household waste.
Products and batteries contain materials that can be recov-
ered or recycled reducing the demand for raw materials.
6
(Original instructions)
Please recycle electrical products and batteries according to
local provisions. Further information is available at
www.2helpU.com
Technical data
Input voltage V
AC
Power input W
No-load speed min
Weight kg
Level of sound pressure according to EN 62841:
Sound pressure (L ) 85 dB(A), uncertainty (K) 3 dB(A)
pA
Sound power (L ) 96 dB(A), uncertainty (K) 3 dB(A)
WA
Vibration total values (triax vector sum) according to EN 62841:
(a ) 11.3 m/s , uncertainty (K) 1.5 m/s
2
h
%

EC declaration of conformity

MACHINERY DIRECTIVE
BEW220 Sander
Black & Decker declares that these products described under
"technical data" are in compliance with:
2006/42/EC, EN62841-1:2015, EN62841-2-4:2014.
These products also comply with Directive 2014/30/EU and
2011/65/EU. For more information, please contact Black &
Decker at the following address or refer to the back of the
manual.
The undersigned is responsible for compilation of the techni-
cal file and makes this declaration on behalf of
Black & Decker.
Black & Decker Europe, 210 Bath Road, Slough,
BEW220
-1
2
R. Laverick
Director of Engineering
Berkshire, SL1 3YD
United Kingdom
31/07/2018
230
150
14000
1.27