Assembly - SPORTSTECH WRX700 Manuel

Step 1
Before the first use, you must mount the seat onto the rail. For easier mounting unfold the device to
its full length (see the section "unfolding").
First, disassemble the pre-installed bumpers (see step 2)!
Run the seat at the end of the track so that the rollers on the side of the seat are on top and the
rollers under the seat are under the edge of the rail. All lateral rolls are lying straight on the rail and
there is a nothing blocking the sliding motion.
Step 2
Screw the supplied bumpers to the end of the rail. These stabilize the rail and prevent the seat from
sliding backwards and off the device.

ASSEMBLY

Firmly tighten all component parts
and pre-assembled parts!
Note: The indentation on the seat
must be aligned to the rear and ser-
ves to relieve the spine and coccyx
during rudder movement.
Remove the bumper before inserting
the seat!
Bumpers
35