Assembling The Microscope; Power Supply; Use Of The Software - Bresser DST-1028 Mode D'emploi

9 Assembling the microscope

This microscope is designed for operation with a Windows PC.
For the assembly proceed as follows:
1. Screw the running rail with the preassembled microscope holder into the holding thread. Make
sure that the holder is facing forward as shown.
2. NOTICE! For higher observation objects, the supplied extension piece can first be screwed
into the mounting thread. The rail is then screwed into the extension piece. This will increase
the working height significantly.
3. Loosen the fixing screw on the holder and unscrew it slightly so that it does not block the retaining
ring.
4. Insert the microscope head into the holder and hand-tighten the fixing screw.

10 Power supply

Plug the USB-A connector of the USB cable into a free USB port of the PC. The power is supplied
through the computer after it has been switched on. The LED ring lighting will light up.
11 Connecting to a PC
Use of this digital microscope requires a connection via USB to a PC running the Windows 10 operat-
ing system. Follow the steps below for proper connection:
1. Download and install the CamLabLite* software on the PC.
2. Mount the digital camera as described.
3. Insert the USB-A plug of the USB connection cable into a free USB port of the PC. If the connec-
tion is successful, the LED lights up. The digital microscope is ready for use.
4. The CamLabLite* software can be used to view and save images from the digital microscope. Fur-
thermore, various image optimizations can also be made. Please also read the separate software
instructions.
*Information about downloading the software and the software instructions can be found on page 2 of
this manual.

12 Use of the software

For this digital microscope, we offer extensive software for editing and saving your digital images. This
can be downloaded from the product page via the following link ("Software" section).
Furthermore, you can also find detailed software instructions in different languages under this link
(section "Instructions").
https://www.bresser.de/P5808600
System requirements:
PC/notebook with Intel i3, i5, i7 or i9 processor from 2nd generation or AMD FX or Ryzen processor,
operating system Windows 8.1/10/11, free USB 2.0 port, internet connection for software download
13 Adjusting the lighting
The digital microscope is equipped with a LED ring lighting for optimal object illumination and can be
dimmed continuously.
1. Connect the digital microscope to the PC.
2. Once the LED lighting is on, the brightness can be adjusted continuously by turning the dimmer
with on the USB cable.
7 / 24