Ultraflex UFLEX Manuel D'installation Et D'entretien page 14

10 Make three Ø 5.5 mm (0.22") holes with maximum depth of 25 mm
(0.98") to fix bracket (A A A A A ) and Ø 10mm (0.39") (through) central hole to
allow the passage of the power cable.
11 Insert the actuator (2) power cable
(1) into the central hole. Then put the
actuator on the upper bracket (3). Insert
the power cable into the transom hole.
Place the bracket as close as possible
to the transom and seal the cable
passage hole, the rear part of the
bracket and the preholes of the fixing
screws using sealant 3M 5200 as
explained in the product instructions.
12 Fix the upper bracket (3) by means
of the supplied screws.
Wait for the sealant 3M 5200 to dry as
explained in the product instructions
(generally 24-48 hours).
page 14
of 79 -
ELECTROMECHANICAL TRIM TABS
Installation and maintenance manual
2 2 2 2 2
1 1 1 1 1
3 3 3 3 3
3 3 3 3 3