Preparing Hot Water; Preparing A Cappuccino - Krups LATT'ESPRESS EA829 Mode D'emploi

Place a cup under the coffee outlet. You can lower or raise the coffee outlet to suit the size of your cup (17).
A message will indicate that you have requested two cups.
The appliance will automatically run two complete coffee preparation cycles.
Double cup function (using the double espresso accessory)
Your appliance enables you to prepare two cups of coffee or espresso for the following three preparations: espresso/strong
espresso/coffee. This function is not available for long coffee drinks.
You have prepared your appliance. The drinks selection menu has appeared.
Place the double cup accessory under the coffee outlet.
Place 2 cups under the accessory's coffee outlets. You can lower or raise the coffee nozzle with the accessory to suit the size
of your cup.
A message will indicate that you have requested 2 cups.
Install the steam nozzle on the machine. Select the hot water recipe from the drinks selection menu. A message invites you to
To interrupt the hot water function, simply press any button.
If the nozzle is obstructed, unblock it with the needle provided.
The maximum quantity of water per cycle is limited to 300 ml.
We recommend that you use very fresh, very cold pasteurised or UHT milk, recently opened. Unpasteurised milk does
not produce the best results.
Preparing and installing a milk jug
Pour milk into the jug (at least 150 ml) (18). Put the lid on the jug by screwing it down with light pressure (19). Lift the locking
lever (20). Install the milk jug on the machine by connecting it to the steam outlet (21), then lowering the locking lever (22). Insert
Ensure that the system's lid button is in the cappuccino position (25).
Making a cappuccino
While the screen is displaying the drinks selection menu, give a short press (< 3 seconds) on the machine's cappuccino button
(26).
you can interrupt the cycle by pressing OK.
nb the cycle does not stop immediately.
A message appears on the screen telling you to clean the system. We recommend you to carry this out, referring to the
paragraphs CAPPUCCINO SYSTEM RINSING and/or MANUAL MAINTENANCE OF THE CAPPUCCINO SYSTEM.
The machine enables you to set the quantities of milk and coffee according to your desires for a perfectly personalised
cappuccino.
You can alter these settings via the Cappuccino Settings menu.
While the screen is displaying the drinks selection menu, give a long press (> 3 seconds) on the machine's cappuccino button.
1. Select Standard for the factory settings
2. Select New to personalise your recipe. The following stages take place:
a. Pre-heating of the machine
b. Milk frothing phase: press OK when the volume of milk required is reached.
c. Coffee phase: press OK when the volume of coffee required is reached.
The machine will indicate that the new volumes have been recorded for the next cappuccinos.
24
OK button.

PREPARING HOT WATER

PREPARING A CAPPUCCINO

(23) then place the other end beneath the magnetic drink outlet (24).
CAPPUCCINO SETTINGS
(27).