General Maintenance - Krups LATT'ESPRESS EA829 Mode D'emploi

Descaling programme - duration: around 22 minutes
descaling operation.
The amount of limescale collected depends on the hardness of the water used. The appliance will warn you by periodically
displaying a message when it is time to carry out descaling.
To carry out a descaling programme, you will require a container with a capacity of at least 0.6 L and a KRUPS F 054 (40 g)
descaling sachet (35).
When the message "Descaling necessary" is displayed, you can start the automatic descaling programme by pressing the PROG
button.
Carefully follow the instructions given on the screen, ensuring that the contents of the sachet have dissolved.
The descaling cycle is divided into three parts: the descaling phase itself, followed by two rinsing phases.
Use only KRUPS descaling products. Descaling products are available from KRUPS After-Sales Service centres.
We accept no responsibility for damage caused to the appliance by the use of other products.
If the appliance is dropped while not in its packaging, it is recommended that you take it to an approved repair centre to avoid
If a power failure takes place or if you unplug your machine, the cycle will continue from the current phase when the power
is returned. It will not be possible to cancel this operation.
Ensure that the descaling programme has been completed to avoid any risk of poisoning. The descaling cycle is an intermittent
cycle. Do not put your hands beneath the steam nozzle during the cycle.
Ensure that you protect your worktop during descaling cycles, particularly if it is made of marble, stone or wood.
To carry out a cleaning programme, you will require a container with a capacity of at least 0.6 L and KRUPS XS 4000
cleaning liquid (36).
Turn the cappuccino system's lid button to the position CLEAN (25).
You can start the cleaning cycle by pressing the button PROG
Follow the instructions on the screen.
MANUAL MAINTENANCE OF THE CAPPUCCINO SYSTEM
To disassemble the system, follow the following instructions:
Remove the flexible pipe from the jug opening and the drinks outlet (37).
Remove the air nozzle: this is the piece located above the black silicone body. (41). To clean this part thoroughly, rinse the
flexible area while pinching it (42). Leave it to soak in hot water and some washing up liquid, then rinse.
The cappuccino system is now completely disassembled (44).
You can also remove the milk inlet pipe together with the lid setting button (48).
Once the elements have been cleaned with warm water and dried, put them back in place and replace the cassette on the jug.

General maintenance

Always remove the mains power cord from the electrical socket and allow the appliance to cool before cleaning it.
Do not use utensils or products likely to scratch or corrode the appliance.
Wipe the outside of the appliance with a damp cloth.
Rinse the water tank with clean water.
These parts are not dishwasher safe.
26
CAPPUCCINO SYSTEM CLEANING
(38).
(39).
(40).
(43).
(45)
(46)
Maintenance Cappuccino cleaning.
(47)