Numatic HZQ 190 Mode D'emploi page 16

Information for DRY USE Vacuum Cleaners
WARNING
Read the instruction manual before using the machine.
Operators shall be adequately instructed on the use of these machines.
As with all electrical equipment, care and attention must be exercised at all times during use,
in addition to ensuring that routine and preventative maintenance is carried out periodically to
ensure safe operation.
Failure to carry out maintenance as necessary, including the replacement of parts to the correct
standard could render this equipment unsafe and the manufacturer can accept no responsibility in
this respect.
This machine is for DRY USE only and must not be stored outside or used in wet conditions.
The machine shall be disconnected from the mains by removing the plug from the supply socket
during cleaning or maintenance and when replacing parts or converting the machine to another
function.
This machine is not a toy
CAUTION
Ensure that the filtration system fitted to the machine is suitable for the material being collected.
This machine is for dry use only.
This machine is for use indoors only.
This machine should be stored indoors only.
NOTE
This machine is also suitable for commercial use, for example in hotels, schools, hospitals,
factories, shops, rental businesses and offices for other than normal housekeeping purposes.
DO
● Keep your machine clean.
● Keep filters clean.
● Use filter bags, they will enhance performance and help keep machine clean.
● Use a Numatic Original filter bag under fine dust conditions.
● Keep hoses and tubes clear.
● Replace any worn or damaged parts immediately.
● Regularly examine the power cord. If damage is found such as cracking or ageing the power
cord
must be replaced by a qualified person using the correct Numatic original part.
● Change dust bag frequently.
● Keep diffuser filter (where fitted) clean.
● Only use the socket outlet on the machine for purposes specified in the instructions
● Only use the brushes provided with the machine. The use of other brushes may impair safety.
● Only replace the power cord with the correct Numatic approved replacement part.
DON'T
● Allow the rotating brush to come into contact with the supply cord (where rotating brushes are
fitted).
● Unreel the cable with one pull or pull on the cable to unplug the machine from the power supply.
● Use to suck up hot ashes or lighted cigarette ends.
● Use steam cleaners or pressure washers to clean the machine or use in the rain.
● Immerse in water for cleaning.
● Attempt machine maintenance or cleaning unless the power supply plug has been removed
from the supply outlet.
233984 Page 16 of 48 (A02)