Important Safety Instructions; For Your Safety; Electrical Information - Heat Controller RG-51L Mode D'emploi

Heat Controller

IMPORTANT SAFETY INSTRUCTIONS

For some models, the power
NOTE
supply cord with this air conditioner
contains a current detection device
designed to reduce the risk of fire.
Please refer to the section Operation
Please refer to the section "Operation
of Current Device" for details.
of Current Device for details.
In the event that the power supply
cord is damaged, it cannot be
repaired-it must be replaced with a
cord from the Product Manufacturer.
Do not, under any
circumstances, cut,
remove, or bypass
the grounding prong.
Power supply cord
with 3-prong grounding plug
and current detection device
Operation of Cur rent Device
(Applicable to the unit adopts current detection device only )
The power supply cord contains a current device that senses damage to the power cord. To test your power
supply cord do the following:
1. Plug in the Air Conditioner.
2. The power supply cord will have TWO buttons on the plug head. Press the TEST button, you will notice a
click as the RESET button pops out.
3. Press the RESET button, again you will notice a click as the button engages.
4. The power supply cord is now supplying electricity to the unit. (On some products this it also indicated by
a light on the plug head.)
NOTES:
Do not use this device to turn the unit on or off.
Always make sure the RESET button is pushed in for correct operation.
The power supply must be replaced if it fails reset when either the TEST button is pushed, or it cannot be
reset. A new one can be obtained from the product manufacturer.
If power supply cord is damaged, it cannot be repaired. It MUST be replaced by one
Cooling operation
product manufacturer.
Heat operation
Room Air Conditioner with R-410A
Outdoor Temp: 64.4-109.4°F (18-43°C) (T
Indoor Temp: 62.6-89.6°F (17-32°C) (T
Outdoor Temp: 23.0-75.2°F (-5-24°C) (T
Indoor Temp: 32.0-80.6°F (0-27°C) (T

For your safety

WARNING
Do not store or use gasoline or other flammable vapors and liquids in
the vicinity of this or any other appliance.
Avoid fire hazard or electric shock. Do not use an extension cord or an
adaptor plug. Do not remove any prong from the power cord.
Electrical Infor mation
WARNING
Be sure the electrical service is adequate for the model you have
chosen. This information can be found on the serial plate, which
is located on the side of the cabinet and behind the grille.
Be sure the air conditioner is properly grounded. To minimize
shock and fire hazards, proper grounding is important. The power
cord is equipped with a three-prong grounding plug for protection
against shock hazards.
Your air conditioner must be used in a properly grounded wall
receptacle. If the wall receptacle you intend to use is not adequately
grounded or protected by a time delay fuse or circuit breaker,
have a qualified electrician install the proper receptacle.
Ensure the receptacle is accessible after the unit installation.
Do not run air conditioner without side protective cover in place.
This could result in mechanical damage within the air conditioner.
Do not use an extension cord or an adapter plug.
Environment)
1
Environment)
1
Environment)
1
Environment)
1
4
4
69.8-125.6°F (21-52°C) (T Environment)
obtained from the
3
62.6-89.6°F (17-32°C) (T Environment)
3
19.4-75.2°F (-7-24°C) (T Environment)
3
32.0-86.0°F (0-30°C) (T Environment)
3
Owner's Manual