Error Display - Sharp UA-KIN50E Mode D'emploi

The product makes a clicking or ticking
sound.
• The product may make clicking or ticking sounds
when it is generating ions.
The Cleanliness Indicator is blue even
when the air is not clean.
• The air may have been dirty when the product
was plugged in. Unplug the product, wait one
minute, and then plug the product in again.
The Cleanliness Indicator is red even
when the air is clean.
• Dirty or clogged Sensitive Dust Sensor openings
interfere with sensor operation. Gently clean the
Sensor Filter or the Back Panel.
The Cleanliness Indicator changes
colour frequently.
• The Cleanliness Indicator automatically changes
colour when the Sensitive Dust Sensor and Odour
Sensor detect impurities. If you are concerned
about the change, you can change sensor
sensitivity. (Page 12, 13)
Filter Maintenance Lamp is on.
• Whenever after performing maintenance or
replacing the Humidifying Filter, connect the
power cord to an outlet and then press the Filter
Reset Button for more than 3 seconds.
(Page 14)
The Display is turned off.
• When the Light Control is set to "Auto", the light
automatically turns off when the room is dark or
operating in sleep mode. Moreover, when the
Light Control is set to "Turn off", the light is always
off.
If you do not want the light to be off, set the Light
Control to the "Dim" setting. (Page 12)
The Display does not match weather
report or another hygrometer or
thermometer in the room.
• Outdoor and indoor as well as the home
environment (the volume of traffic nearby, number
of stories in home, etc.) may cause a reading
different than those data.
• There is a difference in the level within the same
room.
The Humidify Indicator on the Display
does not light up when the tank is
empty.
• The room has reached the appropriate level of
humidity and has stopped humidifying.
• Check the styrofoam float for impurities. Clean
the Humidifying Tray. Make sure that the product
is on a level surface.
The water level in the tank does not
decrease or decreases slowly.
• Check to see if the Humidifying Tray and
Water Tank are correctly installed. Check the
Humidifying Filter.
• If the filter is extremely dirty, clean or replace it.

ERROR DISPLAY

EN-20
• The concentration of
Plasmacluster ion is descending.
Maintain the Plasmacluster
Ion Generating Unit (Electrode
Section).
• Make sure that the Humidifying
Filter, Humidifying Tray and
Roller are properly installed, and
then turn the power to ON again.
• Make sure the Plasmacluster
Ion Generating Unit inserted
properly.
Pull out the Plasmacluster Ion
Generating Unit and insert it to
the end again, and then carry out
the operation again.
• Unplug the product, wait one
minute, and then plug the product
in again.