Red Sea ReefWave Manuel D'utilisation page 20

Red Sea ReefWave ®
On/Off
All units of a particular device type or each individual unit can be
switched On/Off as required. This does not disconnect the unit or put it
out of service. It just sets the intensity to zero. For ReefWave it puts the
pumps into a "No-Wave" state.
Device Manager > Device Type Line and Device Manager > Device Line
– On/Off
Notifications
When the ReefWave has a permanent connection to the internet, a
notification will be sent to your SMD whenever connection to the unit is
lost.
A "No communication" message could be due to a power or internet
outage, router failure or a fault with a specific connected device.
If you have more than one Red Sea connected device and connection
to one or more (but not all) devices are lost, you will receive a "Partial
communication" message. You will then be able to see the current
status of all devices from the Device Manager.
In addition to the connectivity ReefBeat will also notify you if you have
activated the Maintenance or Emergency shortcuts and have forgotten to
disable them.
You can set how you wish to receive some of the messages from
"Notifications" in the homepage main menu.
20
Changing aquarium from Online to Offline
When changing the connectivity state of an Online aquarium with
ReefWave to Offline the Reefwave unit can continue to run the last
implemented 24-hour schedule with all of its customized waves
however the ReefBeat App will not be able to communicate with the
device. Shortcuts and Notifications are disabled and the App will show
all ReefWave units on that aquarium on the homepage as "Controller
Mode" without access to the settings dashboard. All settings however
are stored and returning the aquarium to Online will restore full ReefBeat
functionality with all of the previous settings providing the ReefWave
was not disconnected from the home network.