Reefwave Controller - Red Sea ReefWave Manuel D'utilisation

Red Sea ReefWave ®

ReefWave Controller

Power Indicator LED
Red light when DC power is available.
Wi-Fi Settings Button and Status LED
If indicator LED is off (ReefWave Wi-Fi is off):
Pressing button for 5 seconds (until double blink) activates Wi-Fi AP mode.
If indicator LED is blinking (ReefWave Wi-Fi is in AP mode):
Pressing button for 5 seconds (until double blink) switches Wi-Fi off.
If indicator LED is on (ReefWave Wi-Fi is connected to a Wi-Fi network):
Pressing button for 5 seconds (until double blink) disconnects the ReefWave
from the network and switches it to Wi-Fi AP mode. (Note: before
disconnecting a ReefWave from a network, delete the specific ReefWave
from ReefBeat via the Device Manager.)
Clear Settings:
Pressing the button for 15 seconds (until double blink) deletes all user
settings and switches off the Wi-Fi. Complete the reset process by
disconnecting and reconnecting the DC power. (Note: before initiating "clear
settings," delete the specific ReefWave from ReefBeat via Device Manager.)
Wave Mode Button
The Wave Mode settings button toggles the wave program between the 5
built-in Controller Mode waves and the fully programmable ReefBeat mode.
To change the operating mode, activate the mode button by pressing for
1 second, on releasing the button the mode and intensity LEDs will start
blinking and will continue blinking while the mode function is active. A
short press on the mode button will advance the mode by one step to the
right as indicated by the position of the blinking mode indicator LED. Set the
desired wave by pressing and holding the mode button until the LEDs stop
blinking. Note: If the desired wave is not confirmed by holding the button,
after 4 seconds the current position will automatically be selected.
12
Flow Intensity
dial (10-100%)
Pause/Play &
Feed button
Power & Wi-Fi
Wi-Fi Settings
Status LEDs
& Reset
Button
Pause/Play & Feed
Local Feed Mode: To activate the local Feed mode press the Pause/
Play button for about 1 second. When active the button will blink on/
off once per second. Wave mode, intensity and direction LEDs will switch
off for the duration of the feed mode. After 30 minutes the Feed mode
will automatically switch off and the chosen wave (and all indicator LEDs)
will resume. To switch off the feed mode manually before the end of the
30-minute period, press the Pause/Play button for about 1 second.
Pause/Play: To stop the pump press the Pause/Play button for about 3
seconds. When active the button will blink on/off every 5 seconds. Wave
mode, intensity and direction LEDs will switch off. To restart the pump,
press the Pause/Play button for about 3 seconds and the chosen wave
(and all indicator LEDs) will resume.
Flow direction
indicator LEDs
Wave mode
selector button
ReefBeat Mode
wave programs
5 on-board
default wave
programs