Red Sea ReefWave Manuel D'utilisation page 19

Firmware Updates
From time to time you may receive a notification that a new firmware
version is available for your ReefWave. It is important to keep your
ReefWave firmware updated to ensure compatibility with updates to the
ReefBeat app. If your ReefWave is not permanently connected to the
internet, you will need to connect it temporarily in order to update the
firmware.
Device Manager > Device Type Line and Device Manager > Device Line
– will show the "new firmware available" icon. You can decide to do the
update for all of the devices together or one at a time.
Do not unplug the ReefWave while it is downloading and installing the
new Firmware.
When the firmware update is complete, the "About" page will show
the new version as the current version together with the date and time
that the update was performed. Device Manager > Device Line menu >
About. All of your previous settings will remain as before.
If the firmware update is not successful, the ReefWave will automatically
revert to the previous version. Repeat the process a few minutes later.
If your ReefWave does not seem to be performing correctly after the
update, disconnect and reconnect the power by the DC jack and wait for
the ReefWave to restart.
Removing a ReefWave - Temporary
When switching off or physically removing a ReefWave temporarily such
as when doing reef-scaping or other maintenance on the aquarium or
pump, set the unit to "Out-of-service" through the Device Manager to
prevent ReefBeat from giving you notifications that communication with
the unit has been lost. When returning the unit and/or switching it back
on, remember to return its status to "In-service". To change the status:
Device Manager >Device Line menu > In-service / Out-of-service.
Removing a ReefWave - Permanent
When permanently removing a ReefWave from an aquarium or before
resetting the unit's memory, delete the unit from the ReefBeat app:
Device Manager > Device Line menu > Delete.
Deleting before it is switched off will prevent unnecessary notifications
that communication with the unit has been lost.
Clear ReefWave settings
To permanently remove all user settings from the memory of the
ReefWave and return it to its initial default state, perform the following
steps.
Permanently remove (Delete) the specific ReefWave from ReefBeat.
Press the Settings button on the device for about 15 seconds (until
the indicator LED shows a double blink), release the button and wait
for about 10 seconds until a second double blink of the indicator LED
appears. Disconnect and reconnect the power by the DC jack and wait
for the ReefWave to restart. The unit will restart without any user
settings and with the Wi-Fi switched off, exactly as shipped from the
factory. The unit will retain the latest installed version of the firmware.
Red Sea ReefWave ®
ENG
19