Operation; Working Hints - Brill 2800 MH Mode D'emploi

audible in the control housing.
This is attributable to the inte-
grated electromagnetic coil and

Operation

No shredding residues must be
.
present inside the shredder!
Observe the safety recommen-
.
dations - Wear ear protectors!
After using the shredder for
.
about 1 hour, check that all the
blades are still properly fixed.
Tighten any loose screws imme-
diately!
When connecting the shredder
.
to an extension lead, it must be
ensured that the cable lays
loosely on the ground and that
no tension is exerted on the

Working hints

Ø max.
5 cm
Organic waste of all kinds can
.
be shredded.
Remove soil and stones from
.
roots. Tough, glutinous
materials should be mixed
with dry branches in order
to avoid blockages.
Check that all
.
parts have
been proper-
ly assembled!
Shorten thick
branches to
50 – 60 cm.
should not be considered as
a defect.
connecting socket of the garden
shredder.
Note:
In case of unfavourable mains
conditions, transient voltage
fluctuations that may affect other
units can occur during the switch
on procedure. Such faults are not
expected with mains impedances
< 0.43 Ohm.
To switch on:
Activate green ON-switch 6.
To switch off:
Activate red OFF-switch 7.
After each use see that the
.
shredder is empty!
After use for long periods
.
check the tightness of the
blades!
Always unplug the shredder
.
after use!
If the motor blocks, switch off
.
immediately!
Check material to be shredded
.
first for foreign bodies (remove
GB
21