Elements Of The Machine; Protection Of The Shredder; Before Starting - Brill 2800 MH Mode D'emploi

Check for correct phase
sequence!
Direction of rotation must be
to the left (looking at the blade
GB
plate).
If direction of rotation is to the
right, invert the phases at the
connector socket. There are two
line contact pins on a swivel
insulation piece on this connector
socket which is blocked by
means of a pressure block.

Elements of the machine

1 Filling funnel
2 Feeding tube
3 Tool compartment
4 Tubular frame (lower part)
5 Wheels
6 ON-switch (green)

Protection of the shredder

Carefully observe the
following recommenda-
tions to avoid damage!

Before starting

After take off of the packing your
shredder is ready for use.
The indicated power supply has
to be the same as the one of the
electric network. Connect the unit
20
If the motor runs in the wrong
direction, the pressure block
need merely be pushed back
with a screwdriver and the insu-
lation piece turned round. This
takes only a few seconds, and
the motor will then run in the
right direction.
The phase sequence may vary
from one mains to another.
7 OFF-switch (red)
8 Main connection
9 Motor cover with motor
10 Upper part of housing
discharge cover
Do not remove or bridge the
.
switching and safety devices!
If the cutting blades are
.
blocked, switch off the
shredder immediately!
by revolving the strap at the out-
let (240 V). The units are equip-
ped with a zero voltage release.
While connecting the unit to the
mains a bussing noise may be