Brill 2800 MH Mode D'emploi page 19

Connect the shredder only to
.
properly earthed power points.
The connection should be of
.
rubbersheathed cable, to be
type 05 RN-F minimum, with
a conductor cross section of
1.5 mm (up to 25 m) or
2
2.5 mm for more than 25 m,
2
resp. The power point must
be fitted with a shower proof
cover guard.
Insert the plug into the power
.
point only when the unit is
switched off.
Do not press the on/off switch
.
with a sharp or pointed object.
Children under 16 and persons
.
not familiar with the operation
of the shredder should not
operate the unit under any
circumstances.
Note that the operator is
.
responsible for the safety of
third parties within the operat-
ing range of the shredder.
Never operate the shredder
when people are nearby.
When using your shredder
.
always wear strong shoes,
gloves and safety glasses.
(We also recommend to wear
ear protectors when shredding!)
Do not wear loose hanging
.
clothing or clothing with hang-
ing ribbons or cords.
Hands, other body parts and
.
clothing are not to be put into
the filling chamber, discharge
channel or near other moving
parts.
Do not transport or tilt the shred-
.
der while the motor is running.
Keep proper footing and
.
balance at all times.
Operate unit only under condi-
.
tions of sufficient visibility.
Always disconnect it from the
.
mains, prior to working on the
unit.
Never remove any safety
.
devices during operation.
Warning: Rotating cutting
.
blades. Do not reach into
ejector funnel.
Warning: Blades continue to
.
revolve when switched off!
Check your fuse protection:
.
230 V: 16-A (slow blow);
400 V: 10-A (slow blow)
380 V – 400 V
.
(three-phase current model)
GB
19