Cleaning; Troubleshooting; Safety Notices; Fault Indications - CASO DESIGN TC 2100 Thermo Control Mode D'emploi Original

16.2 Cleaning


Ceramic hob, Housing, external thermometer and Operating Panel
 Clean the hob, the housin, external thermometer and operating panel of the device
with a soft, slightly damp cloth.
Attention
► In order not to damage the plastic components, do not use any solvent-based cleaning
detergents such as, for example, petrol.

17 Troubleshooting

This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:

17.1 Safety notices

Attention
► Only qualified electricians, who have been trained by the manufacturer, may carry out
any repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and
damages to the device.

17.2 Fault indications

In the event of a fault, an error code will appear in the display; it describes the cause of the
fault.
Display Description
E05 Overheating Protection: This means that the temperature had increased to a
temperature of 270°C. In this case the device turns off automatically in order to
avoid damages. In case of "E05" please pull the power plug in order to reset
the device. After this you can use it again as usual.
► If error messages continue to be displayed after an extended waiting period or after
restarting the appliance, then it must be sent to Customer Service to be examined.

17.3 Causes and rectification of faults

The following table assists in localizing and rectifying minor faults.
Fault
Display is empty
► If you are unable to solve the problem with the steps shown above, please contact
Customer Service.
Please note
Possible Cause
Power plug not plugged in
Fuse switch not switched on
Please note
To Rectify
Insert plug into mains socket
Switch on fuse switch
48