Hilti DD 150-U Mode D'emploi page 20

2. Position the drill stand on the work surface.
3. Use the 4 leveling screws to level the base plate.
4. Use the jack screw to apply tension to the drill stand and tighten the locknut on the jack screw.
5. Make sure that the diamond core drilling machine is secure.
5.4 Fitting the hand wheel
The hand wheel can be fitted on either side of the drill stand.
▶ Fit the hand wheel on to the shaft.
▶ Secure the hand wheel.
5.5 Fitting the side handle
1. Turn the side handle to release or secure it, as applicable.
2. Check that the side handle is fitted correctly and tightened securely.
5.6 Adjusting the side handle
1. Slacken the side handle by turning it counter-clockwise.
2. Position the side handle.
3. Secure the side handle by turning it clockwise.
4. Check to ensure that the side handle is tightened securely.
5.7 Adjusting the depth gauge (when using the drill stand)
1. Adjust the depth gauge.
2. Secure the depth gauge by tightening the clamping screw.
5.8 Securing the diamond core drilling machine in the drill stand
1. Turn the hand wheel counter-clockwise and pull the locking pin out.
2. Engage the interface plate on to the hook on the drill stand.
3. Push the locking pin in and use the hand wheel to tighten it securely (turn clockwise).
4. Insert the switch locking device into the grip.
The switch locking device can be used to lock the on/off switch in the "on" position for sustained
operation.
5. Close the water valve in the side handle.
6. Connect the water supply.
5.9 Detaching the diamond core drilling machine from the drill stand
1. Lock the carriage on the rail with the carriage lock.
2. Close the water valve in the side handle.
3. Disconnect the water supply.
4. Remove the switch locking device from the grip.
5. Use the hand wheel to release the locking pin (turn counterclockwise).
6. Pull the locking pin out of the slot.
7. Pivot the machine away from the drill stand.
5.10 Enabling a machine equipped with theft protection system (TPS)
1. Plug the supply cord of the diamond core drilling machine into the power outlet.
2. Press the "Reset" or "I" button on the PRCD.
➥ The yellow theft protection indicator LED flashes.
3. Hold the TPS key directly against the lock symbol.
➥ The yellow theft protection indicator LED goes out and the machine is enabled.
If the power supply is interrupted, the product remains ready for operation for approximately
20 minutes. If the interruption is longer, the theft protection system has to be deactivated again
with the TPS key.
12 English
Printed: 09.08.2019 | Doc-Nr: PUB / 5069547 / 000 / 06
6
4
4
7
434950
*434950*