Installing And Removing The Battery - Remington RM4020 Manuel De L'utilisateur

3. Examine the LED. The LED will indicate the battery status:
• Green (blinking): The battery is charging. Charge the battery
until the green light stops blinking.
• Green (constant): The battery is fully charged.
• Red (blinking - slow): The battery and/or charger are too hot
or too cold. Make sure the battery and charger are in an
environment between 32° and 104° F (0° and 40° C). Allow
time for the battery and/or charger to warm up or cool down.
• Red (blinking - fast): The battery is no longer functional. Refer
to the Warranty section for replacement information.
• Red (constant): The battery is not charging. Remove the
battery. Make sure the terminals on the battery and battery
charger are clean. Re-insert the battery into the charging dock.
Push the battery firmly until it locks into place.
4. To maximize the life of the battery, the battery charger will turn
off when charging is complete. Once the battery is fully charged,
remove it from the battery charger. Optionally, the battery can be
stored in the battery charger, but the battery charger should be
unplugged from the power outlet.
To remove the battery: Hold the battery charger in place with
one hand. Press the battery release button with the other hand
(Fig. 4). Slide the battery out of the charging dock.

INSTALLING AND REMOVING THE BATTERY

WARNING:
Avoid accidentally starting the unit. To
prevent serious injury, DO NOT squeeze the trigger lockout
and DO NOT squeeze the trigger when installing or
removing the battery. Refer to Starting and Stopping.
Remove the battery from the unit when it is not in use.
Installing the Battery
1. Grasp the rear handle firmly (Fig. 5). DO NOT squeeze the
trigger. Refer to Starting and Stopping.
2. Slide the battery into the battery port (Fig. 5). Push the battery
firmly until the battery locks into place (Fig. 5). There should be
an audible "click."
3. Gently pull the battery to make sure it is securely locked in place.
Removing the Battery
1. Grasp the rear handle firmly (Fig. 5). DO NOT squeeze the
trigger. Refer to Starting and Stopping.
2. Press the battery release button to unlock the battery (Fig. 5).
3. Pull the battery out of the battery port (Fig. 5).
NOTE: It may require a strong pull to remove the battery.
Rear Handle
Battery Port
11
LED
Fig. 3
Battery Release
Button
Fig. 4
Battery
Release Button
Battery
Fig. 5