Installing And Removing The Battery; Starting And Stopping; Starting Instructions - Remington RM4000 Manuel De L'opérateur

INSTALLING AND REMOVING THE BATTERY

WARNING:
Avoid accidentally starting the unit. To
prevent serious injury, DO NOT press the trigger lockout
and DO NOT squeeze the trigger when installing or
removing the battery. Refer to Starting and Stopping.
Remove the battery from the unit when it is not in use.
Installing the Battery
1. Grasp the shaft grip firmly (Fig. 11). DO NOT press the trigger
lockout and DO NOT squeeze the trigger. Refer to Starting and
Stopping.
2. Slide the battery into the battery port (Fig. 11). Push the battery
firmly until the battery locks into place (Fig. 11). There should be
an audible "click."
3. Gently pull the battery to make sure it is securely locked in place.
Removing the Battery
1. Grasp the shaft grip firmly (Fig. 11). DO NOT press the trigger
lockout and DO NOT squeeze the trigger. Refer to Starting and
Stopping.
2. Press the battery release button to unlock the battery (Fig. 11).
3. Pull the battery out of the battery port (Fig. 11).
NOTE: It may require a strong pull to remove the battery.

STARTING INSTRUCTIONS

NOTE: To help prevent the motor from starting accidentally, this unit
has a trigger lockout. The trigger lockout and trigger must both
be engaged to start the unit.
1. Install the battery. Refer to Installing the Battery.
2. Press and hold the trigger lockout (Fig. 12).
3. Continue to hold the trigger lockout. Squeeze and hold the
trigger to start the unit (Fig. 12).
4. Release the trigger lockout, but continue to squeeze the trigger
to the degree needed for the operation.
STOPPING INSTRUCTIONS
1. Release the trigger (Fig. 12).
2. Wait for all moving parts to come to a complete stop.
NOTE: Upon release of the trigger, the trigger lockout will reset to
the locked position.
Shaft Grip

STARTING AND STOPPING

12
Battery Port
Battery Release Button
Fig. 11
Trigger Lockout
Trigger
Fig. 12
Battery